|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#14
August 8th 03, 12:17 PM
|
|||
|
|||
I got lots of hours holding sticks between my knees too. I would prefer a centre stick too. But a properly built and rigged canard should be able to keep right side up once you've got it trimmed, I would have thought. So you should be able to release the stick for short periods if you really need both hands. Big John ++++++++++++++++++++++++++++++++++++++++++++ Why are you picking on the early model Mooney's? g Barnyard BOb -- 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Tailwheel question | Steve B | Aerobatics | 4 | January 30th 04 03:35 AM |
| Hinges under stress - mechanical engineering type question | Corrie | Home Built | 21 | August 6th 03 08:49 AM |
| question on intercoms for my new homebuilt | w b evans | Home Built | 1 | July 23rd 03 12:57 AM |
| Canard static port location | Paul Lee | Home Built | 1 | July 12th 03 02:55 AM |
| Pitts Screw Question | VTflyer | Home Built | 1 | July 2nd 03 11:02 AM |
Threaded Mode