|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#9
June 7th 05, 11:47 AM
|
|||
|
|||
Hi Dick et all
Is there a similar mod available for the Nimbus 2, I am rebuilding a Nimbus at the moment and always thought that area could benefit from fairings, pictures or drawings would do I can work from there. Chris Runeckles Western Australia wrote in message oups.com... You described the fairing installation procedure well JJ, and that is just how I did mine. But do not forget to describe sawing off the 4 inches of each flap root. Otherwise it is real difficult to move the flaps. Dick Johnson 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Wing tip stalls | mat Redsell | Soaring | 5 | March 13th 04 05:07 PM |
| Wing root fairings | D.A.L | Soaring | 10 | October 29th 03 11:36 AM |
| wing root strakes (not canard A/C) | Wallace Berry | Home Built | 0 | October 2nd 03 08:47 PM |
| Props and Wing Warping... was soaring vs. flaping | Wright1902Glider | Home Built | 0 | September 29th 03 03:40 PM |
| An Affordable Homebrue 60 in DS machine | Grant | Soaring | 0 | August 8th 03 03:52 AM |
Threaded Mode