![]() |
If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#11
|
|||
|
|||
![]()
The reason these engines failed is MORE COMPLICATED than the fact they
were at 41,000'. These planes can fly at 41,000'. What happened is related to how they got to 41,000'. They got there by exceeding the maximum climb rate. The plane was empty so it climbed very fast. But due to some complicated factors, the engines cannot go to that altitude that fast. They overheated. This was a published limitation. They exceeded it. Even my simple explanation is not adquate as it is more complicated than this. This is due to the fact that I don't completely understand it either. And to answer your question, yes it is safe to operate at max altitude, if the pilot follows all of the correct procedures when operating the plane and if the plane does not have damage and has been maintained correctly etc. The plane has been tested there, and higher still, so there is some safety factor. These engine failures were from some complicating factors. Not just as simple as flying too high. One word of advice. Don't get your accurate information from the newspapers. You have to go deeper to get accurate information. |
Thread Tools | |
Display Modes | |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
AOPA Stall/Spin Study -- Stowell's Review (8,000 words) | Rich Stowell | Aerobatics | 28 | January 2nd 09 02:26 PM |
Palo Alto airport, potential long-term problems... | [email protected] | Piloting | 7 | June 6th 05 11:32 PM |
rec.aviation.aerobatics FAQ | Dr. Guenther Eichhorn | Aerobatics | 0 | November 1st 03 06:27 AM |
rec.aviation.aerobatics FAQ | Dr. Guenther Eichhorn | Aerobatics | 0 | October 1st 03 07:27 AM |
Where to soar near Jefferson City - Missouri? | Peter | Soaring | 2 | September 15th 03 03:29 PM |