![]() |
If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#5
|
|||
|
|||
![]()
In your first post you state that you had a blade strike, flew under
wires, landed on an obviously too small pad and parked too close to a building in a very confined area. What are you trying to do, catch the attention of your local FSO? Or just displaying every possible bad move all at once? Where do you fly and for whom? I still say you are an RC guy... wrote: Didn't even bother to ask what that was all about? Geeezzzz....don't bother to read anymore of my posts then and don't learn something new. This board seemed to be getting stale so I thought I'd toss out something for discussion. Ummmm, last time I looked in my logbook it was pushing pretty hard on 22,000 hours and well over 8000 in helicopters. How about you? In addition, my licenses read ATP, MEL, SELS, IFR Rotor, CFI/IRAM. Long ways from a wannabe......... |
Thread Tools | |
Display Modes | |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
Help ! SMALL Radial engine | Chris Wertman | Home Built | 12 | July 18th 05 02:46 PM |
Small plane noise is destroying my life | Robert Morien | General Aviation | 5 | December 1st 04 05:01 PM |
Which plane for 5 small pax? | Adam Aulick | Home Built | 46 | August 18th 04 03:44 PM |
AD's for small aircraft engines--Spec. 0-470 series | Dave Flatter | Owning | 2 | October 18th 03 11:22 PM |
SIFL Tax question for small business owners | Dave | Owning | 4 | August 24th 03 02:43 PM |