|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#7
June 22nd 05, 12:29 PM
|
|||
|
|||
Why not us a cutoff tool on your lathe instead of a band saw?
Dan, U. S. Air Force, retired Because they're too big. Your cut off tool would have to stick out the radius of the part that you're cutting, and you'd loose too much rigidity. Besides, a good bandsaw is faster. The real question is why spend an hour making something you can buy for $10.00, and probably at half the weight? 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Hi Guys. First Time Poster | zachary397 | Piloting | 0 | March 18th 05 12:32 AM |
| Cessna 15X for heavy guys | 10Squared | Piloting | 12 | February 20th 05 03:57 AM |
| Nice Guys in Aviation | Michael 182 | Piloting | 9 | March 11th 04 03:07 PM |
| Have you guys (and gals) heard of this??? | Grzechu | Soaring | 9 | March 1st 04 07:44 AM |
| Awright, you guys | C J Campbell | Home Built | 3 | September 1st 03 03:03 AM |
Threaded Mode