|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#9
July 14th 05, 04:23 PM
|
|||
|
|||
When I get to my panel, which isn't going to be soon, I'll probably do it on the mill. But for those who don't have access to a machine shop, I wonder why you're talking about hole saws and fly cutters. Don't the Greenlee type punches work pretty well? You only need a small pilot hole and a couple of wrenches. 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Are All Batteries Created Equal? (Does Size Matter?) | [email protected] | Soaring | 4 | July 17th 05 02:04 PM |
| DIGGING A DEEPER HOLE | Cribsheet | Piloting | 3 | December 10th 04 12:00 AM |
| Oil Temperature sending unit | Corky Scott | Home Built | 2 | October 19th 04 12:58 AM |
| Finding vent hole in wing skin | Martin Eiler | Soaring | 7 | November 21st 03 01:44 PM |
| Fairing question... | Tina Marie | Home Built | 5 | July 16th 03 12:18 AM |
Threaded Mode