|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#3
August 18th 05, 02:34 PM
|
|||
|
|||
It is indeed the same screw, but the mating surfaces of the chuck are
not perfect and tightening only one hole will cause some off centering. Tightening all three holes reduces any such tendency. Ask any machinist they will tell you "tighten at all holes". 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Why is Soaring declining | f.blair | Soaring | 266 | February 7th 09 12:58 PM |
| Antique ex-freon now used as air compressor seen this type? | Jason D. | Home Built | 12 | November 17th 04 03:07 PM |
| Non-Flying Ladders | Veeduber | Home Built | 5 | July 10th 04 05:15 AM |
| Lathe Help | Bruce A. Frank | Home Built | 15 | February 7th 04 09:05 AM |
Threaded Mode