![]() |
If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#10
|
|||
|
|||
![]()
Recently, Greg Copeland posted:
Is this common? How many run their tank(s) dry as part of their fuel management strategy? If you don't run dry, why not? Two main reasons; there are better ways to gauge your fuel consumption rate, for example, logging how much fuel you put back in the tank after the flight; and why play with the trim to keep the plane going in a straight line, then start all over again with that fiddling when you switch tanks? Aside from the heat beat skipping which is sure to follow the first couple of times, what's the down side to this strategy? Besides being pointless? How about being uneccesarily risky? Neil |
Thread Tools | |
Display Modes | |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
Time, running out of fuel and fuel gauges | Dylan Smith | Piloting | 29 | February 3rd 08 07:04 PM |
Engine running again, the good, bad and ugly | Corky Scott | Home Built | 34 | July 6th 05 05:04 PM |
It's finally running! | Corky Scott | Home Built | 19 | April 29th 05 04:53 PM |
Rotax 503 won't stop running | Tracy | Home Built | 2 | March 28th 04 04:56 PM |
Leaving all engines running at the gate | John | Piloting | 12 | February 5th 04 03:46 AM |