![]() |
If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#7
|
|||
|
|||
![]() "Scott" wrote in message ... I think it's the other way around...what can a Maule do that a Scott 3200 can't do? SHIMMEY! Years ago we put a Maule pneumatic on our Cessna 140 to replace the hard rubber tire Scott 2000. Never could get the Maule to work well, so we went back to the Scott. The other thing that is nice on the 3200 is dual forks. That just HAS to be better than a single fork in rough field operations... Scott Scott, I have seen those Scott forks bend, warp, crack, break and be re-welded. Knock on wood, but I have never seen that big brawny fork on a Maule crack or break. I have never had a Maule shimmy on my aircraft, but have fixed a Cub's Maule that shimmied because the tailsprings had been improperly installed and the wheel was mis-rigged. Let's hear it from the bushplane boys in Alaska. That's where a tailwheel does the ultimate duty. BTW, a friend just got back from ferrying a VG'd two-ten to Wasilla, AK. He said on the destination airport was an old Taylorcraft with a two-hundred horsepower Lycoming on the nose. jls wrote: wrote in message ups.com... and what can a Scott 3200 do that the Maule can't do? |
Thread Tools | |
Display Modes | |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
Scott 3200 tail wheel | IAN DONALDSON | Home Built | 1 | August 8th 05 01:58 AM |
Tailwheel units on ebay | Victor Bravo | Home Built | 1 | July 24th 05 09:47 AM |
Wally Scott inducted into TX Hall of Fame | [email protected] | Soaring | 0 | June 25th 05 04:27 AM |
SCOTT RITTER SAYS U.S. PLANS JUNE ATTACK ON IRAN | [email protected] | Naval Aviation | 1 | February 22nd 05 05:06 PM |
Advice on flying Pitts with Haigh Locking Tailwheel | Ditch | Home Built | 19 | January 4th 04 10:18 PM |