![]() |
If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#5
|
|||
|
|||
![]()
This website gives quite an interesting history of Kamov who have been
making co-axials for many years http://avia.russian.ee/vertigo/peopl...v/index_2.html and are the makers of this latest one. On this latest single place the lower swashplate is visible in some photos and it looks like the pitch arms for the upper rotor go down the center of the main shaft. Regards Peter "Stuart & Kathryn Fields" wrote in message ... Very interesting. I can't see any pitch control linkage to the blades. Don't read Russian, but do they say anything about autorotation? -- Stuart Fields Experimental Helo magazine P. O. Box 1585 Inyokern, CA 93527 (760) 377-4478 (760) 408-9747 general and layout cell (760) 608-1299 technical and advertising cell www.vkss.com www.experimentalhelo.com "Blue" wrote in message u... Interesting new co-axial from Russia. Not too much info yet as it is a prototype. However all static and ground tests made, flying time only 12 hours. More info will be available after all tests. Check out these web sites for info. http://www.airtrikes.net/heli.jpg http://delta.wtr.ru/wtboard/40671.shtml www.clubrotor.ru |
Thread Tools | |
Display Modes | |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
Mini-500 Accident Analysis | Dennis Fetters | Rotorcraft | 16 | September 3rd 05 11:35 AM |
Lockheed wins Presidential helicopter contract | Tiger | Naval Aviation | 0 | January 29th 05 05:24 AM |
Musings of a Commercial Helicopter Pilot | Badwater Bill | Home Built | 6 | February 27th 04 09:11 AM |
Musings of a Commercial Helicopter Pilot | Badwater Bill | Rotorcraft | 0 | February 25th 04 06:39 PM |
Helicopter crash video | James Blakely | Piloting | 17 | December 30th 03 03:21 PM |