![]() |
If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#3
|
|||
|
|||
![]()
And remember, there is an absolutely wonderful and free calibration point at
212°F available for nothing more than a pan of water and a hotplate. Jim wrote in message ... Remember, this advice is worth exactly what you paid for it... TC |
Thread Tools | |
Display Modes | |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
Old CHT probe replacement | Frank Ch. Eigler | Owning | 3 | August 31st 05 03:22 PM |
T.E. Probe Question | KP | Soaring | 2 | July 27th 05 02:58 PM |
Replacement JPI EGT probe | Robert M. Gary | Piloting | 4 | July 16th 05 02:28 AM |
Cleaning a 3-way TE probe | Jack Glendening | Soaring | 37 | November 5th 03 06:45 PM |
Broken line to Oil Temperature Probe, Repairable? | rkane33 | Owning | 2 | July 25th 03 03:19 AM |