|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#11
September 19th 05, 04:13 AM
|
|||
|
|||
cut parts from...but that is not a sport plane
 A metal sport plane canbe built very very well with basic sheet metal tools. The high dollar stuff would be a waste of money unless you needed production speed of an automobile assembly line. I've never built a plastic injection mold, but I've built airplanes That's exactly the point, we're talking about production speeds. The equipment you're talking about will not churn out a finished plane every 2 minutes at an affordable price. I'm talking about CNC machines in cells with robots, and stamping machines, and injection molds. 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Washington DC airspace closing for good? | tony roberts | Piloting | 153 | August 11th 05 12:56 AM |
| Enjoy High Quality incredible low cost PC-to-phone and broadband phone services | John | Home Built | 0 | May 19th 05 02:58 PM |
| Boeing Boondoggle | Larry Dighera | Military Aviation | 77 | September 15th 04 02:39 AM |
| Fwd: [BD4] Source of HIGH CHTs on O-320 and O-360 FOUND! | Bruce A. Frank | Home Built | 1 | July 4th 04 07:28 PM |
| Could it happen he The High Cost of Operating in Europe | Larry Dighera | Piloting | 5 | July 14th 03 02:34 AM |
Threaded Mode