|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#22
September 27th 05, 02:55 AM
|
|||
|
|||
Yes, bare aluminum is porous, the anodizing 'seals' it.
"nrp" wrote in message oups.com... Some random points on props: A Mil Spec manual somewhere showed that anodizing reduces the fatigue strength of aluminums about as much as shot peening can increase it. They must do anodizing for other reasons - maybe to provide some corrosion resistance? 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Engine Balancing and Resonance Vibration Problem | AllanFuller | Owning | 13 | September 12th 05 12:51 AM |
| A Rec.Aviation FRS Channel @ Oshkosh this year? | Bob Chilcoat | Piloting | 10 | June 19th 05 03:32 PM |
| my ignorance | LCT Paintball | Home Built | 25 | April 9th 05 06:54 PM |
| Instrument overhaul - Are all overhauls created equal? | RonLee | Home Built | 1 | February 7th 05 06:35 PM |
| Naval Air Refueling Needs Deferred in Air Force Tanker Plan | Henry J Cobb | Military Aviation | 47 | May 22nd 04 03:36 AM |
Threaded Mode