![]() |
If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#8
|
|||
|
|||
![]() UltraJohn wrote: Evan Carew wrote: For those of us who use Mozilla/Thunderbird/Netscape there is the concept of putting someone in your message filters. Don't know if this possible in Microsoft land, but should be. Do what thou wilt. Apparently the current US distributors are not the problem, but rather a previous one. I remember very well a post on Usenet about a guy who bought an engine overseas, before a US dealer existed. When one was appointed, he refused to sell the guy any parts to punish him for buying it "around him", even though he wasn't the dealer then, and the works refused to ship him parts because there was a dealer in the US! However I am unable to find that post. Still, the Jabiru is an expensive noncertificated engine, with only one parts line, and it turns a small prop fast. In that it combines the lesserly-desirable aspects of aircraft engines and non-aircraft engines. |
Thread Tools | |
Display Modes | |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
Bad cylinder | Denny | Owning | 17 | September 12th 05 06:04 PM |
Path of an airplane in a 1G roll | Chris W | Piloting | 47 | July 4th 05 10:53 PM |
Path of an airplane in a 1G roll | Chris W | Aerobatics | 20 | June 29th 05 09:35 AM |
Path of an airplane in a 1G roll | Chris W | Home Built | 22 | June 29th 05 09:35 AM |
Start Anywhere Cylinder (SSA rules proposal) | Mark Navarre | Soaring | 15 | September 25th 03 01:13 PM |