![]() |
If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#13
|
|||
|
|||
![]()
Nope, there wasn't enough room between "runway" and "stop" for "two zero".
He definitely said "downwind runway two, stop-and-go". There was no zero. Yes, but =she= (the next week) spoke slower, and with a more varied cadence. Non-use of the leading zero trumps the use of it, no question about it. Well, the discussion here shows that there =is= some question about it, just not in your mind. I tend to agree with you that non-use is probably better. However, it is not without benefit. As for being nonstandard, that's just a matter of changing the standard. Elsewhere they use a different standard, but the laws of physics are the same. That possibility is not limited to runway 2/20 either, as the field may have an intersecting runway it could be confused with, such as runways 1/19 an 10/28. Good point. Jose -- Money: what you need when you run out of brains. for Email, make the obvious change in the address. |
Thread Tools | |
Display Modes | |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
"Cleared Straight-In Runway X; Report Y Miles Final" | Jim Cummiskey | Piloting | 86 | August 16th 04 06:23 PM |
Diamond DA-40 with G-1000 pirep | C J Campbell | Instrument Flight Rules | 117 | July 22nd 04 05:40 PM |
Procedure Turn | Bravo8500 | Instrument Flight Rules | 65 | April 22nd 04 03:27 AM |
F15E's trounced by Eurofighters | John Cook | Military Aviation | 193 | April 11th 04 03:33 AM |
Ham Radio In The Airplane | Cy Galley | Owning | 23 | July 8th 03 03:30 AM |