![]() |
If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#15
|
|||
|
|||
![]()
I think "relay" is the correct terminology for this component. I
thought they were referred to as "relay switches", but all sites I have seen do refer to them as "relays". I'll have to go in and take a closer look to see if there are any other numbers on this panel to be able to respond more accurately. My last trip up to the airport, I tried to document names and model numbers of all avionics in the panel so I could provide better data. The audio panel didn't have a name on it that I could decipher... All I could recall getting from it was the info off the relay, including the manufacturer and part number. I don't recall if there was any additional information??? I also don't have any idea how old it is? I was surprised, however to find that the relay for a second COM and marker beacon components were removed. That's what I get for buying used and having it installed sight-unseen! I'm learning some valuable lessons, the hard way! If anyone cares, I will post an update after I've had a chance to get up and look at the audio panel again... May be a few days... Thanks again for the feedback! Todd |
Thread Tools | |
Display Modes | |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
MX385 Radio removal | Marty from Florida | Owning | 3 | May 24th 13 08:26 AM |
Engine Balancing and Resonance Vibration Problem | AllanFuller | Owning | 13 | September 12th 05 12:51 AM |
(sorta OT) Free Ham Radio Course | RST Engineering | Home Built | 51 | January 24th 05 08:05 PM |
(sorta OT) Free Ham Radio Course | RST Engineering | Piloting | 43 | January 24th 05 08:05 PM |
RF interference issue again (esp. for E Drucker and Jim Weir and other RF wizards) | Snowbird | Home Built | 78 | December 3rd 03 09:10 PM |