![]() |
If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#11
|
|||
|
|||
![]()
I fly with a gear warning and several times it has told me that I had
lowered the U/C but not locked it home properly. On the other side I personally know two very experienced pilots on the types they were flying who happily landed with no wheel despite the incessant beeping. Personally I think the BGA is right in that I'd much rather land with the wheel up than stall at 10 feet up despite the cost that could ensue. Mind you my Astir would probably win even if I landed on the tarmac :-) Cheers Robin In message , Bob Gibbons writes For what its worth, for many years now as I transition to a new glider, one of the first things I add is two small squares of colored plastic tape, a green block at the end of the "gear down and locked" end of the handle travel, and a red block at the "gear retracted" end of the handle travel. As I turn final, I will often take a quick glance at the gear lever to make sure it is at the "green" end. Bob On 18 Nov 2005 16:45:40 GMT, Nyal Williams wrote: There is a solution to this problem; I learned it the hard way. Say to yourself 'The gear HANDLE is at the gear-down ICON. A fellow in Minden told me this beforehand. I didn't pay a lot of attention. I paid a lot of money. Now I use this phrase religiously. I switched between three new to me gliders in 4 days. The retract movement was in opposite directions on two of them. I went the lwrong way on the last flight. Use the words HANDLE and ICON. At 22:24 16 November 2005, Marc Ramsey wrote: Mike the Strike wrote: I prefer check lists, but must note I have seen another colleague return from a flight with gear extended then retract it on final as he went through his pre-landing checks! Same thing happened to me on my first flight in the first glider I owned. On pattern entry I went through my pre-landing checklist, operated the gear handle, opened the spoilers, then heard a load beeping noise. Closed the spoilers, beeping stopped. It took a fair bit of contemplation to recognize that the glider might have a gear warning system. A quick glance at the gear position symbols allowed me to solve the mystery while still plenty high. I must have forgotten to retract the gear after release... Marc -- Robin Birch |
Thread Tools | |
Display Modes | |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
Jet engines vs. leaf blowers | 01-- Zero One | Soaring | 6 | September 8th 05 01:59 AM |
Gear Warning Switches on a Mosquito | scooter | Soaring | 6 | March 9th 05 01:15 PM |
Aluminum vs Fiberglass landing gear - Pro's and cons. | Bart Hull | Home Built | 2 | November 24th 03 05:23 AM |
Aluminum vs Fiberglass landing gear - Pro's and cons. | Bart D. Hull | Home Built | 0 | November 22nd 03 06:24 AM |
gear warning plus | K.P. Termaat | Soaring | 0 | September 8th 03 08:33 AM |