![]() |
If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#32
|
|||
|
|||
![]()
"three-eight-hotel" writes:
Thanks! I will do that... Off topic question: The audio panel from the front, has every indication that it has marker beacons (O, M, I indicators), but there's nothing there... Simply no led's or wires to the panel. This would seem like a fairly simple thing to implement??? Should I just cut my losses and be happy I can communicate, or am I getting greedy, thinking I could go to Radio Shack and with minimal effort, upgrade this existing audio panel by myself? Does the panel have the decoders; just no indicators? It could be the PCB section for that function was never populated, or it's a daughter board that was not installed... -- A host is a host from coast to & no one will talk to a host that's close........[v].(301) 56-LINUX Unless the host (that isn't close).........................pob 1433 is busy, hung or dead....................................20915-1433 |
Thread Tools | |
Display Modes | |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
MX385 Radio removal | Marty from Florida | Owning | 3 | May 24th 13 08:26 AM |
Engine Balancing and Resonance Vibration Problem | AllanFuller | Owning | 13 | September 12th 05 12:51 AM |
(sorta OT) Free Ham Radio Course | RST Engineering | Home Built | 51 | January 24th 05 08:05 PM |
(sorta OT) Free Ham Radio Course | RST Engineering | Piloting | 43 | January 24th 05 08:05 PM |
RF interference issue again (esp. for E Drucker and Jim Weir and other RF wizards) | Snowbird | Home Built | 78 | December 3rd 03 09:10 PM |