|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#27
December 22nd 05, 06:11 AM
posted to rec.aviation.homebuilt
|
|||
|
|||
"Must Have" Tools for Christmas
someone wrote:
One of these days, I'm going to get cozy with someone who really knows their way around a machine shop. Perhaps by being polite, even when disagreeing, you might one day obtain such an invitation. Jon (whose shop just acquired a new HAAS machining center to replace one of the Bridgeport CNC mills) in California 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Camloc Installation Tools | jls | Home Built | 13 | May 7th 04 05:11 AM |
| EAA Chapte Tools | [email protected] | Home Built | 7 | March 8th 04 10:51 PM |
| Why do you buy Snap-on tools? | Anonymo421 | Home Built | 12 | November 9th 03 09:40 AM |
Threaded Mode