![]() |
If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#2
|
|||
|
|||
![]()
Jim Burns wrote:
FWIW, I'm a satisfied customer. Thanks Jim...you probably just make Skyranch some more money since, after reading the Avweb article, I feel guilty and that the only way to make reparations for my transgressions is to buy and use a filter cutter. :-) Heck, it's less than .1 AMU for the filter cutter...not something that happens very often in aviation. -- Jack Allison PP-ASEL-IA Student Arrow N2104T "When once you have tasted flight, you will forever walk the Earth with your eyes turned skyward, for there you have been, and there you will always long to return" - Leonardo Da Vinci (Remove the obvious from address to reply via e-mail) |
Thread Tools | |
Display Modes | |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
Which oil can cutter? | Jim Burns | Owning | 13 | December 2nd 05 04:37 AM |
Century IIIB Rate Filter Parts and Schematics | PilotMike2004 | Owning | 1 | January 10th 05 12:01 PM |
Filter element for Frantz filter | Philippe | Owning | 1 | April 20th 04 08:23 PM |
where exactly to put the noise filter | Dico Reyers | Owning | 25 | February 25th 04 03:21 AM |
Airwolf oil filter system | kevin | Owning | 3 | August 7th 03 04:24 PM |