|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#4
January 6th 06, 04:39 PM
posted to rec.aviation.homebuilt
|
|||
|
|||
Fiberglass adhesion to aluminum?
On Fri, 06 Jan 2006 05:59:37 GMT, Richard Lamb
wrote: If a fiberglass patch on an aluminum backplate stays on for one entire trip around the pattern, I'd be flat out amazed... Properly preped it'll stay on as well as the paint, better in some cases. Without a good degrease and prep I doubt it'd stay on past the run up. :-)) Many of our "plastic" planes have Aluminum to glass/resin bonds. Roger Halstead (K8RI & ARRL life member) (N833R, S# CD-2 Worlds oldest Debonair) www.rogerhalstead.com 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Aluminum vs Fiberglass landing gear - Pro's and cons. | Bart Hull | Home Built | 1 | November 24th 03 02:46 PM |
| Aluminum vs Fiberglass landing gear - Pro's and cons. | Bart Hull | Home Built | 2 | November 24th 03 05:23 AM |
| Aluminum vs Fiberglass landing gear - Pro's and cons. | Bart Hull | Home Built | 0 | November 24th 03 03:52 AM |
| Aluminum vs Fiberglass landing gear - Pro's and cons. | Bart D. Hull | Home Built | 0 | November 22nd 03 06:24 AM |
| Fiberglass Tip Tanks Question | Jay Honeck | Owning | 7 | September 26th 03 04:23 AM |
Threaded Mode