![]() |
If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#3
|
|||
|
|||
![]()
"Shawn" sdotherecurry@bresnannextdotnet wrote:
Some claim UV light can penetrate a fiberglass top and that the accumulated irradiation of the glider will cause damage to the ship. I used to fly at Boulder, CO where all of the trailers are parked oriented nearly east-west exposing a long southern face to the Colorado sunshine. Trailers occupy the same spot for years on end, and, not that I've taken a poll, but I've never heard of any ships with damage to the top of one wing and the bottom of the other, or one side of the fuse or fin due to a fiberglass top. Could it be because sun in Colorado in summer shines straight DOWN? ![]() Seriously though, can fiberglass top be painted with aluminum silver (inside or outside) for added UV protection? Shawn -- Y |
Thread Tools | |
Display Modes | |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
KA6E and Foka 4 comparable metal ships - Laister Nugget LP15 | Matthieu | Soaring | 18 | June 7th 05 01:20 AM |
Repairing fiberglass wheel pants | Jay Honeck | Owning | 18 | September 25th 04 03:55 AM |
Aluminum vs Fiberglass landing gear - Pro's and cons. | Bart Hull | Home Built | 2 | November 24th 03 05:23 AM |
Aluminum vs Fiberglass landing gear - Pro's and cons. | Bart Hull | Home Built | 0 | November 24th 03 03:52 AM |
Fiberglass Tip Tanks Question | Jay Honeck | Owning | 7 | September 26th 03 04:23 AM |