![]() |
If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#21
|
|||
|
|||
![]()
: How often do you change oil? Confirm you have a full flow filter (it
: reads like you do). Does your oil filter have gray (lead) sludge in : it? Full flow filter, 50 hours, Aeroshell 80/100 depending on winter/summer. No lead sludge in the filter, and very tiny (i.e. normal) amount of metal and carbon in the filter and its element. : What fraction of the time since you got the engine has been 100LL vs : autofuel? I assume the autofuel has to be 91 octane autofuel to handle : your compression? 93 A.K.I autofuel is used for local cruise. Generally at least 25% 100LL on the takeoff tank. I'd say in the 3-400 hours since we've run it, probably about 60% on autofuel. : Have you ever tried to do a mag check at cruise? (i. e. could one mag : be somehow intermittent at temperature?). Done in-cruise mag checks. All fine. I generally check it along with my leaning to verify no rough on just one mag. : Be sure to check inside the rocker covers to see if the rocker shafts : are wearing on the cover sides. I found one (but only one) in my 172M : (1700 TT over 31 years) that was worn substantially. Later shafts have : a nylon thrust boss. Will look when I get them off. Probably take a look on Saturday. : You gotta post what you find. THX Will do. -Cory -- ************************************************** *********************** * Cory Papenfuss * * Electrical Engineering candidate Ph.D. graduate student * * Virginia Polytechnic Institute and State University * ************************************************** *********************** |
Thread Tools | |
Display Modes | |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
Replacing fuel cut-off valve with non-a/c part??? | Michael Horowitz | Owning | 46 | January 15th 05 10:20 PM |
Lycoming 0-360 factory overhaul core charges - Does Air Powertell the truth ? | Mike Spera | Owning | 6 | December 13th 04 01:13 AM |
Harley engine special | Brett | Home Built | 106 | May 28th 04 03:10 AM |
Q: Disecting a cut-off valve? | Michael Horowitz | Home Built | 0 | March 6th 04 01:47 PM |
Lycoming Sued | jls | Home Built | 0 | February 13th 04 02:01 PM |