DG-300 instrument panel

"Bruce" wrote in message
...
wrote:
Thanks Bill, I just happen to have some 1/8" plexiglass in my shop
from when I built my router table, so I have that tool too! I might
try and get hold of a carbon fiber blank and use that for a svelt
looking panel!

Carbon is not a good idea for an instrument panel. In a crash it will be
strong enough to break legs before it breaks, and when it does break it
will be sharp enough to lacerate efficiently.

There are good safety reasons for the BGA recommendation of building a
nice, not too strong instrument panel in glass fibre.

--
Bruce Greeff
Std Cirrus #57
I'm no-T at the address above.

I understand the crash protection concerns but changing materials in an
older glider worries me. It's quite possible that the instrument panel is
itself a structural member - even if in hindsight that was a bad idea.
Replace the solid original with a frangible one and you may have compromised
cockpit strength perhaps gaining nothing or even losing a little safety in
the process.

Old glider are, well, old gliders and there are risks associated with flying
them. You get what you pay for. If you really want the latest in crash
protection, dust off the checkbook and buy a new one.

Bill Daniels