![]() |
If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#10
|
|||
|
|||
![]()
There were two rationales given in this thread, and both of them make
sense to me... but which one would you say is more correct? a) stay to the right to make it easier to see the traffic (sitting in the left seat), b) stay to the right to stay away from the pattern (and away from the departing plane's presumed crosswind turn). The reason for asking, of course, is what should you do if the pattern is RH - sidestep to the left or right? I've only had to go around for traffic once and it was a weird situation. I was cleared for T&G on 31. 28 starts to the right of 31, intersects it, and obviously continues to the left. I was on short final when tower cleared someone for takeoff on 28; he started rolling. Since i wanted no part of playing chicken at the intersection, I immediately went around (then announced it), flew the centerline and probably the tower gave me right traffic to stay away from the departure end of 28. The other guy's takeoff clearance was not canceled, and he departed. At the time (pre-solo), I was a little rattled, the tower said "sorry about that" and my instructor said I did the right thing. But, after reading this thread, it made me think about it some more, and I realize I likely did not keep the traffic in sight and in fact may have passed directly over him at some point (certainly a possibility even if it didn't actually happen that way). So, now I think perhaps I should have done something differently, but what? Not crossing 28 would be difficult at best (the airport is KAGC if anyone wants to look at a diagram) - for one, it's going to involve really low altitude turns - no way you're missing the approach end by turning right, and if you go left you're headed towards the hangars and tower. You're also not going to have a lot of choice about your airspeed during the initial stages of the go-around. So what to do? I know now that a 172 should easily be able to land and stop before the intersection, but even now (a whopping ~25 hours later) I wouldn't be entirely comfortable with that... todd |
Thread Tools | |
Display Modes | |
|
|