If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#26
|
|||
|
|||
Leaning (was Gene Whitt is back on line)
"Matt Barrow" wrote in message ... | | "Jim Macklin" wrote in message | news:tslKf.100258$4l5.99449@dukeread05... | Yes, engine roughness is caused by one cylinder misfiring. | Fuel injection is properly calibrated is the same on all | cylinders so the engine runs smooth and balanced. | | | I guess GAMI is selling us a bill of goods, huh? :~) | | | ( Moved to the bottom where it belongs for those that read top-to-bottom) "Jim Macklin" wrote in message news:1brKf.101334$4l5.3648@dukeread05... It all depends, Henry Ford built the "best" car he could when he built the Model T, a 1962 Chrysler 426 Hemi would have really seemed like magic to Ford and a modern double overhead cam engine in a 2000 Acura would really would out perform that 426 monster cube for cube. Huh? GAMI is better than stock FI which is a very old, low tech constant flow system on Continental and Lycoming engines. Your car uses high pressure pumps a fuel rail and solenoid control metering at the injector, but engine roughness is caused by __________ which causes __________ vibration. Do you have any idea what GAMI injectors are? |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
I want to build the most EVIL plane EVER !!! | Eliot Coweye | Home Built | 237 | February 13th 06 03:55 AM |
Dawley Aviation PIREP, or: Atlas is BACK | Jay Honeck | Owning | 33 | January 4th 06 03:05 PM |
1343 NM to the NASM Udvar-Hazy Center and back... | Jay Honeck | Piloting | 25 | June 18th 05 05:07 PM |
Space Elevator | Big John | Home Built | 111 | July 21st 04 04:31 PM |
The Little Wheel in Back | Veeduber | Home Built | 6 | September 8th 03 10:29 AM |