Lathe, drillpress, milling machine available, but.....

("Highflyer" wrote)
[snip]
I have a rolling workbench in my hangar that I made. I built it out of
leftover oak cabinet parts when I was building my wife's kitchen cabinets.
I had it all finished and I was trimming 1/16 of an inch off of one side
of the cabinet doors so they would fit properly on my 3HP cabinet saw.


I built a rolling workbench from cabinet inserts they removed, to install
dishwashers, in our old apartment. Two sections, a 2-ft space, and then a
third cabinet section = 8-ft long rolling workbench!

I cut a 3/4 inch piece of plywood for the top and put 8 (nice) casters on
the bottom - 4 on each side of the middle space.

Each of the three sections has one pull-out drawer and two doors on the
bottom. Cheap(free) ...except plywood and casters.

I was so proud of myself ...UNTIL ...I needed to clamp/QuickGrip my first
piece of work down.

Um, I failed to factor in a lip - on either end, or in the front. There was
a clamping spot available in the middle space, but that was it. Doh!


Montblack
Live and learn!