![]() |
If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#16
|
|||
|
|||
![]() "David Lesher" wrote in message ... "Dave Stadt" writes: That's not exactly what could happen in a brake circuit. We are talking brake circuits not crankcase. Leave oil exposed to the atmosphere and it does not absorb air. Nope, just water..... but in any case the key issue is having a fluid that has very low compressibility even at high temperatures. (Look at the NOVA series on the 777; the rejected-takeoff test has the solid carbon rotors glowiing bright orange as the rims melt...now THAT'S hot....). Even a small amount of suspended air makes it compressable. And oil, unlike brake fluid, does not err ?stratify? well. Automotive brake fluid was, ISTM, the very first federal automotive safety standard. It must have: Traditional automotive brake fluid is alcohol based and is hydroscopic. A can will become useless in a matter of hours if not tightly capped. It is not oil based. Ahem.. it's not alcohol-based; it's glycol based. (Except DOT-5 which is silicon..) Ahem..glycol is.....well why don't you look it up. |
Thread Tools | |
Display Modes | |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
Cherokee Pilots Association Fly-In Just Gets Better and Better | Jay Honeck | Piloting | 7 | August 8th 05 07:18 PM |
Cherokee National Fly-In & Convention | Don | General Aviation | 0 | May 5th 04 08:12 PM |
Cherokee National Fly-In & Convention | Don | Piloting | 1 | March 20th 04 05:27 AM |
Cherokee National Fly-In & Convention | Don | General Aviation | 0 | March 20th 04 02:15 AM |
Building the Po' Boy Bending Brake | Veeduber | Home Built | 14 | March 1st 04 06:15 PM |