![]() |
If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#14
|
|||
|
|||
![]() "Jim Macklin" wrote in message news:zVz%f.3168$8q.1032@dukeread08... 5-4-24. Contact Approach a. Pilots operating in accordance with an IFR flight plan, provided they are clear of clouds and have at least 1 mile flight visibility and can reasonably expect to continue to the destination airport in those conditions, may request ATC authorization for a contact approach. b. Controllers may authorize a contact approach provided: 1. The contact approach is specifically requested by the pilot. ATC cannot initiate this approach. EXAMPLE- Request contact approach. 2. The reported ground visibility at the destination airport is at least 1 statute mile. 3. The contact approach will be made to an airport having a standard or special instrument approach procedure. 4. Approved separation is applied between aircraft so cleared and between these aircraft and other IFR or special VFR aircraft. EXAMPLE- Cleared contact approach (and, if required) at or below (altitude) (routing) if not possible (alternative procedures) and advise. c. A contact approach is an approach procedure that may be used by a pilot (with prior authorization from ATC) in lieu of conducting a standard or special IAP to an airport. It is not intended for use by a pilot on an IFR flight clearance to operate to an airport not having a published and functioning IAP. Nor is it intended for an aircraft to conduct an instrument approach to one airport and then, when "in the clear," discontinue that approach and proceed to another airport. In the execution of a contact approach, the pilot assumes the responsibility for obstruction clearance. If radar service is being received, it will automatically terminate when the pilot is instructed to change to advisory frequency. Note that FLIGHT VISIBILITY of ONE MILE is required and the pilot determines flught visibility. See 5-4-24.b.2. above. Note that the reported ground visibility at the destination airport must be at least 1 statute mile in order for ATC to issue a clearance for a contact approach. Note also that actually reading what you intend to post prior to posting it can help you to appear less stupid. How is it that someone with the ratings and experience you claim to possess was not aware a contact approach required a reported ground visibility of a mile or more? |
Thread Tools | |
Display Modes | |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
Circle to land question | A Lieberman | Instrument Flight Rules | 33 | May 24th 05 04:22 AM |
Confused about great circle navigation | xerj | Piloting | 7 | July 10th 04 05:38 PM |
R in a Circle (Airport Surveillance Radar) on VFR charts | Jeff Saylor | Piloting | 66 | May 12th 04 04:05 PM |
Defensive circle | Dave Eadsforth | Military Aviation | 23 | October 9th 03 06:13 PM |
NACO charts - why have a reference circle? | Bob Gardner | Instrument Flight Rules | 5 | September 6th 03 01:15 PM |