|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#5
May 4th 06, 08:06 AM
posted to rec.aviation.homebuilt
|
|||
|
|||
Aluminum Paint & Inerior antenna?
RST Engineering wrote: OK. Yes or no. ------------------------------------------------- Ditto :-) If you don't want to think about, don't do it. Mount the antenna on the exterior of the airframe (attached to a good ground plane) and go flying. -R.S.Hoover 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Question about Alodine 1201 | Andrew Sarangan | Home Built | 20 | April 11th 06 01:31 PM |
| One coat paint for aluminum? | [email protected] | Home Built | 10 | September 17th 04 07:01 AM |
| Aluminum vs Fiberglass landing gear - Pro's and cons. | Bart Hull | Home Built | 1 | November 24th 03 02:46 PM |
| Aluminum vs Fiberglass landing gear - Pro's and cons. | Bart Hull | Home Built | 2 | November 24th 03 05:23 AM |
| Aluminum vs Fiberglass landing gear - Pro's and cons. | Bart D. Hull | Home Built | 0 | November 22nd 03 06:24 AM |
Threaded Mode