|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
May 6th 06, 06:21 PM
posted to rec.aviation.soaring
|
|||
|
|||
LS-3a flap-fuselage gap seals
Does anyone have a source for mylar that can be used to construct
flap-to-fuselage gap seals for an LS-3a? Also, does anyone know the proper thickness of mylar to get? 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| terminology questions: turtledeck? cantilever wing? | Ric | Home Built | 2 | September 13th 05 09:39 PM |
| Negative flaps for better low speed aileron control? | [email protected] | Soaring | 41 | August 25th 05 06:01 AM |
| kevlar in fuselage | Rick Walters | Soaring | 2 | January 20th 05 10:59 PM |
| Gel headset seals | Brian Burger | Piloting | 2 | September 26th 04 12:00 AM |
| mylar seals wing to flap/ Aileron | culverflyer | Soaring | 2 | May 5th 04 02:52 PM |
Threaded Mode