![]() |
If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#3
|
|||
|
|||
![]() Morgans wrote: "Richard Lamb" wrote But I'm really wondering if the rubber donut is necessary and maybe just make another U'ie that will bolt to the bottom side of the leg end. And get's pinned to the airframe same as the first one, and - yer done? The leg is supposed to flex... Any thoughts? Perhaps the flex of the plate alone, is a bit too stiff? How far down, from the attach point, is the donut? If it is very far down from the hinge, it might put a point of stress on it, that would bend the plate, before it flexes. Also, you have to consider the stress on the airframe attach point of the donut. If it were a solid mounting, instead of a donut, a sudden impact of a rough landing could over stress the frame. The donut spreads the load out over a period of time, lowering the peak stress, I would think. All in all, this is mostly conjecture, because the drawings and your description do not contain enough detail for me to fully and accurately understand all of the implications of the structures. -- Jim in NC I know how you feel, Jim. I often feel the same way after staring at it for a while... Richard |
Thread Tools | |
Display Modes | |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
Lyc. O-360 cylinder question | JB | Owning | 13 | November 27th 04 09:32 PM |
Handheld battery question | RobsSanta | General Aviation | 8 | September 19th 04 03:07 PM |
A question on Airworthiness Inspection | Dave S | Home Built | 1 | August 10th 04 05:07 AM |
Question | Charles S | Home Built | 4 | April 5th 04 09:10 PM |
Partnership Question | Harry Gordon | Owning | 4 | August 16th 03 11:23 PM |