|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
May 27th 06, 07:40 PM
posted to rec.aviation.homebuilt
|
|||
|
|||
Torque Value for Mounting an O-320 wide deck.
Dear Group,
I am in the process of building my cowling and have the engine up on the mount. What I need to know is what is the amount of torque on the engine mount bolts? I have rebuild manuals, parts manuals and the owners manual but can't find a torque for tightening. The engine is a dynafocal mount O-320-E2D which is a wide deck. Also after the bolts are torqued, will I be able to remove the engine and use the same rubber mounts upon final installation? Or simply tell me where I could find that information. Thanks. -- John "Ebby" Ebensperger Hatz Classic s/n37 Camden, NY 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Continental A-75 hub torque | SteveR | Home Built | 8 | July 21st 05 09:49 PM |
| Proper Torque for Fuel Fittings | Steve Waltner | Home Built | 10 | February 20th 05 12:46 AM |
| Drum dia and torque | Bob Johnson | Soaring | 15 | November 22nd 04 07:37 PM |
| Deck height | Sean Trost | Home Built | 5 | July 16th 04 03:46 AM |
| The "Gipper" is ready! | Phineas Pinkham | Naval Aviation | 0 | July 8th 03 10:57 PM |
Threaded Mode