![]() |
If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#18
|
|||
|
|||
![]() "Jack Allison" wrote One hesitancy I'd have with S-turns is when on final. If things are too close, that's the time to plan a go around. If you're S-turning, you might be slowing down the guy behind you and creating more problems. IMHO, if I'm too close to the guy ahead of me, I'd rather go around. Just my 2 cents worth... No argument from me, but an observation. The controllers are good at getting the spacing, and it is usually at altitudes under 200 feet, when things get messed up, by someone not exiting the runway when they are supposed to, or someone not landing on the correct portion of the runway. I've seen all kinds of things done, including s turns (if nobody is close behind you, for you to mess up) and even 360's. Anything is fair game, if the controllers tell you to do it, and if you feel capable. The go-arround and saying unable if always a good way out. Bottom line, everyone arriving at OSH needs to be on their game and able to maintain altitude/heading/speed. If unable, land elsewhere. It's really not hard, anyone who considers themselves current should be able to do the arrival...but it's amazing to see how many folks interpret 1000 AGL and 90 kts differently. Totally agree. It is amazing to me that people with little experience, and not on their game, think they should drop in at peak arrival times. Sometimes, it is obvious that they have not read the notam. I once saw someone in a taildragger RV take three times around to get it on the ground, and even on that last time, it was forced in, and at one point, I though for sure there was going to be a midair and a fireball. Let's all make a wish for everyone getting there, and back home, with no loss of life, this year. Be safe, everyone. -- Jim in NC |
Thread Tools | |
Display Modes | |
|
|