|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#5
July 22nd 06, 07:15 AM
posted to rec.aviation.homebuilt
|
|||
|
|||
Bending graphlite rod
J.Kahn wrote:
The stuff is rolled into coils for shipment. Scroll down and check out the flat version bent by hand into a half circle. Yup, that's the way I get it, spools of 1000 to 1500 feet. 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Bending sheet stock | Michael Horowitz | Restoration | 1 | April 24th 06 04:28 AM |
| Wing Bending Oscillation | jcarlyle | Soaring | 18 | February 21st 06 04:37 PM |
| Bending extruded angle | Veeduber | Home Built | 8 | August 29th 04 12:58 AM |
| Building the Po' Boy Bending Brake | Veeduber | Home Built | 14 | March 1st 04 06:15 PM |
| Minimum bending radius for 0.050" 6061-T6? | Bob Chilcoat | Home Built | 11 | February 5th 04 04:59 PM |
Threaded Mode