|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#15
July 23rd 06, 01:47 AM
posted to rec.aviation.homebuilt
|
|||
|
|||
Aluminum materials related questions
"cavelamb" wrote in message ink.net... Ernest Christley wrote: Peter Dohm wrote: To deburr use a deburring tool which will take the sharp edge off the inside of the tubing and the edges of sheet, finish with scotchbrite pads. Use the 6061-T6. Bob There is also a rotary version of the scotchbrite pad(s) that is really slick. Peter And of what use is slick sandpaper, my good man 8*) Polishing! A better answer that I had when I got back to the computer. Scotchbrite will definitely polish aluminum. 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Question about Alodine 1201 | Andrew Sarangan | Home Built | 20 | April 11th 06 01:31 PM |
| UAV's and TFR's along the Mexico boarder | John Doe | Piloting | 145 | March 31st 06 06:58 PM |
| FA: Book - Aircraft Materials and Processes by Titterton Pub 1937 | Brad | Aviation Marketplace | 0 | November 21st 05 01:59 AM |
| Homebuilt Aircraft Frequently Asked Questions List (FAQ) | Ron Wanttaja | Home Built | 0 | September 2nd 04 05:15 AM |
| Homebuilt Aircraft Frequently Asked Questions (FAQ) | Ron Wanttaja | Home Built | 0 | April 5th 04 03:04 PM |
Threaded Mode