|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#2
August 26th 03, 09:58 PM
|
|||
|
|||
I think you are going to have a hard time finding LED's that are bright
enough to do this and meet the FAA requirements for strobe lights. Juan "pekka1510" wrote in message om... Hello fellow aviators, Does anyone has deeper knowledge of the following thing? I have been thinking to modify Strobe/Nav.Light system. Halogen bulbs will be replaced with ultra bright leds. Benefits; low current draw, cheaper than incandenscent bulbs, long life time. Low points; narrow beam, mechanically challenging .... BUT.... Does semiconductor LEDs work near with strobe flashtubes (HIGH VOLTAGE)??? I am looking ElectroMagneticCompatibility. Anyone experiences or recommendations, please? regards, pekka, FL 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| LEDs | Morgans | Home Built | 6 | August 19th 03 03:49 AM |
| LED for position lights | Jerry Springer | Home Built | 2 | August 19th 03 01:43 AM |
Threaded Mode