|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#3
September 13th 06, 05:51 PM
posted to rec.aviation.homebuilt
|
|||
|
|||
instrument sizes
A big 2 5/16" (58mm) hole, and four small #18 (0.1695, just a shade smaller than 11/64") screw holes with centers spaced 2 5/8" (67mm) apart (ie, the little hole centers are 1 5/16" from the center of the big hole). For comparison, the equivalent numbers on the next diagram for 3 1/8 instruments are 3 1/8" and 3 1/2" respectively. Thanks for the quick reply! When you say #18 screw holes I ssume you mean #18 drill. Are the screw threads 6-32? 4-40? PS- Not trying to talk down to you in my description either  Not at all. I appreciate the clarity. 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Instrument Checkride passed (Long) | Paul Folbrecht | Instrument Flight Rules | 10 | February 11th 05 02:41 AM |
| Instrument Rating Checkride PASSED (Very Long) | Alan Pendley | Instrument Flight Rules | 24 | December 16th 04 02:16 PM |
| Tips on Getting Your Instrument Rating Sooner and at Lower Cost | Fred | Instrument Flight Rules | 21 | October 19th 04 07:31 AM |
| Logging approaches | Ron Garrison | Instrument Flight Rules | 109 | March 2nd 04 05:54 PM |
| PC flight simulators | Bjørnar Bolsøy | Military Aviation | 178 | December 14th 03 12:14 PM |
Threaded Mode