|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
September 16th 06, 10:13 AM
posted to rec.aviation.homebuilt
|
|||
|
|||
Marking sheetmetal
I want to mark sheetmetal for bending.
Can't use a scribe because I'll weaken the metal. Magic Marker is too thick. Pencil doesn't show. What do you use? - Mike 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Wire marking | Scott Vetter | Restoration | 1 | December 1st 04 03:23 AM |
Threaded Mode