|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#28
September 19th 06, 07:46 AM
posted to rec.aviation.homebuilt
|
|||
|
|||
Marking sheetmetal
You are kidding, of course? You are marking a line 40 mils wide and
expecting a piece to come out to 20 mils or better accuracy? Jim "DonMorrisey" wrote in message ups.com... At the risk of beating this subject to death, use a sharpie, however a Fine Point Sharpie is too thick. An Ultra-Fine Point Sharpie makes a line approx 1 MM in width. Don... 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Wire marking | Scott Vetter | Restoration | 1 | December 1st 04 03:23 AM |
Threaded Mode