|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#29
September 19th 06, 08:18 PM
posted to rec.aviation.homebuilt
|
|||
|
|||
Marking sheetmetal
("RST Engineering" wrote)
You are kidding, of course? You are marking a line 40 mils wide and expecting a piece to come out to 20 mils or better accuracy? If the line were 20 mils thick, where would you cut? The middle of the line? The edge of the line? But yes, a thin line is nicer. Montblack "Good enough. No one in the front row will ever notice it." Theater set construction motto! g 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Wire marking | Scott Vetter | Restoration | 1 | December 1st 04 03:23 AM |
Threaded Mode