A aviation & planes forum. AviationBanter

If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.

Go Back   Home » AviationBanter forum » rec.aviation newsgroups » Home Built
Site Map Home Register Authors List Search Today's Posts Mark Forums Read Web Partners

Poll: electrical connector crimpers/dies



 
 
Thread Tools Display Modes
Prev Previous Post   Next Post Next
  #7  
Old October 6th 06, 05:06 PM posted to rec.aviation.homebuilt
Bill Daniels
external usenet poster
 
Posts: 687
Default Poll: electrical connector crimpers/dies

I have always soldered, cleaned and covered with heatshrink. I have NEVER
had a problem with soldered electrical terminals. On the other hand, I have
had many problems with crimped terminals done by others. As I get older, I
need one of those soldering jigs with a BIG magnifying glass.

Soldering is easy to learn and much more secure than crimped terminals.

Bill Daniels

"abripl" wrote in message
ups.com...

Crimped terminals are easier to learn.....

Thats probably the main reason why so many in aviation use it. I can
see the average person trying to solder with a clunky, 100W, steaming
iron and doing a bad job. With crimping there is "little" to learn. But
soldering is hardly a dying art. Zillions of hams, electronic buffs,
use it. A decent temperature controlled soldering iron with a little
practice will prevent wicking past the terminal into the wires - and
not really a problem in most cases. Cold joints can be inspected and
redone. Two big reasons for soldering: 1. Vibration - a real problem in
aviation, promotes crimps loosening. 2. Oxydation/Corrosion, especially
with disimilar metals - seen lots of corroded crimps while soldered
terminals are still holding.



 




Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

vB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Forum Jump

Similar Threads
Thread Thread Starter Forum Replies Last Post
Exposed Electrical Wires in Boeing 737 Fuel Tanks! Larry Dighera Piloting 0 July 17th 06 06:13 PM
UAV's and TFR's along the Mexico boarder John Doe Piloting 145 March 31st 06 06:58 PM
2005 SSA Contest Rules Poll and Election [email protected] Soaring 0 September 27th 05 01:47 PM
Electrical system for Champ 7DC? Jimmy Cash Restoration 3 October 25th 03 08:28 PM


All times are GMT +1. The time now is 06:23 AM.


Powered by vBulletin® Version 3.6.4
Copyright ©2000 - 2025, Jelsoft Enterprises Ltd.
Copyright ©2004-2025 AviationBanter.
The comments are property of their posters.