![]() |
If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#14
|
|||
|
|||
![]()
"Shawn" wrote in message
. .. Gary Emerson wrote: For the benefit of the group, let's hear about what works for re-attaching mylar. ... Now that we've established that the only solvent safe to use on a composite glider is the sweat from a virgin Las Vegas showgirl, can anyone answer Gary's question? Ok, I hate it when some clueless moron comes along and says "I've never tried this, but..." So, I've never tried this, but what about the 3M stripe off wheel? Essentially a rubber wheel you mount in a drill designed to "erase" trim stripes and the adhesive without solvents. A picture is at: http://www.imperialinc.com/items.asp?item=0726310 (I've never dealt with this company, they just came up near the top of the search) -- Geoff The Sea Hawk at Wow Way d0t Com remove spaces and make the obvious substitutions to reply by mail When immigration is outlawed, only outlaws will immigrate. |
Thread Tools | |
Display Modes | |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
Re-curving mylar on a glider | Eric Greenwell | Soaring | 32 | October 18th 06 03:20 PM |
Mylar (again) | JJ Sinclair | Soaring | 0 | December 11th 03 10:40 PM |
Mylar "form 1" vs "form 2" | John | Soaring | 1 | November 27th 03 01:20 AM |
Looking for sand paper rolls and adhesive | Roger Halstead | Home Built | 9 | August 8th 03 08:58 AM |
Structural adhesive question | BD5ER | Home Built | 1 | August 3rd 03 06:03 AM |