![]() |
If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#10
|
|||
|
|||
![]()
In article ,
Blanche wrote: Roy Smith wrote: Blanche wrote: Me, personally, have a 1/2-axis autopilot. Turn it on, it holds the heading. Well, not really. Since it's not coupled to anything, it doesn't know when there's any deviation, such as winds. I can start out on a heading of 120, turn on the AP. If winds are from the north, then my actual track is more southerly, depending on the strength of the winds. I assume you understand the difference between heading and track? Heading: direction in which the longitudinal axis of the aircraft points with respect to true or magnetic north. Heading is equal to course plus or minus any wind correction angle. Course: intended direction of flight in the horizontal plane measured in degrees from north. Track: actual flight path of an aircraft over the ground. Also referred to as ground track. Ref: Aviation Dictionary, Jeppesen, 2003. OK - my bad. I should have stated "start out on a course of 120". But the use of "track" is correct, true? Yeah, I think you got it. I was a little worried from the way you phrased things originally. |
Thread Tools | |
Display Modes | |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
AOPA Stall/Spin Study -- Stowell's Review (8,000 words) | Rich Stowell | Aerobatics | 28 | January 2nd 09 02:26 PM |
tailwheel endorsement | Jose | Piloting | 65 | April 27th 06 01:59 AM |
Training Day before SSA Convention | Paul Remde | Soaring | 6 | November 9th 05 11:00 PM |
Advice and experts with 400 series Cessnas (414 and 421), purchase and training | [email protected] | Owning | 36 | January 9th 05 02:32 AM |
AOPA Stall/Spin Study -- Stowell's Review (8,000 words) | Rich Stowell | Piloting | 25 | September 11th 03 01:27 PM |