![]() |
If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#23
|
|||
|
|||
![]() wrote in message oups.com... wrote: Suprisingly I keep coming back to wood as material for mass production since the whole of the structure could be made of one material. There are obvious logistic benefits there, and I think most wood techniques could be practically achieved robotically. Wood, especially good wood, is getting scarcer all the time. Consistently good wood is hard to find. It's the reason ladder manufacturers went to aluminum and/or fiberglass a long time ago. The big Sitka Spruce and other types of trees that gave us good aircraft-grade wood mostly went to build houses a long time ago when it seemed we'd never run out of the stuff. What's left is protected in parks. The airplanes mentioned in the original post were, I'm pretty sure, cold molded - a very labor intensive process of laying individual strips of veneer - each trimmed to shape - over a plug and either stapled of vacuum bagged until the laminate cures. But other methods exist to build wood stressed skin structures. e.g. "Constant Camber" is a boat building method where full sheets of veneer are placed in a somewhat generic female mold and vacuum bagged - the mold does not have compound curves, but by changing the position of the layup, you get different shaped panels that then can be assembled into whatever. Another option is "tortured plywood" where thin plywood is forced into a compound shape. Amateur boat builders are also using a "stich and glue" technique to make plywood hulls - I wonder how long before someone tries it for an airplane? Or - consider a structure like a KR-2 - a plywood box with some sticks to reinforce. Not a swoopy looking as a Mosquito bomber, but it works and it doesn't require "premium" lumber The hard part would be to come up with a reasonable replacement for the spars in the wings. To avoid the big expensive spruce planks, one might have to consider an engineered product like Laminated Veneer Lumber (LVL)... -- Geoff The Sea Hawk at Wow Way d0t Com remove spaces and make the obvious substitutions to reply by mail When immigration is outlawed, only outlaws will immigrate. |
Thread Tools | |
Display Modes | |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
compound curves in plywood | BA-100 | Home Built | 58 | April 13th 05 05:29 AM |
cvjetkovic ca-65 skyfly- plywood spar? | patrick mitchel | Home Built | 3 | October 16th 04 05:26 PM |
Air Conditioning System for Homebuilts? | JPAviation | Home Built | 18 | February 6th 04 03:24 AM |
Homebuilts by State | Ron Wanttaja | Home Built | 14 | October 15th 03 08:30 PM |
Substitute for Mahogany plywood | Kelvin & Janice Rempel | Home Built | 1 | September 5th 03 08:02 PM |