![]() |
If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#11
|
|||
|
|||
![]()
That sounds a bit frightening - 3500 fpm! What are the stresses on the
glider to get that kind of climb rate? How far away is disaster if the pilot twitches a bit on the controls or hits some wind shear or a thermal? Hmmm, if they are using weak links, I don't see a problem. Stress (=force) is related to acceleration, not to speed. You can go straight up at 1000000 fpm with the same force as at 10 fpm. Just takes you a bit longer to reach the speed. -Gerhard -- Gerhard Wesp / Holderenweg 2 / CH-8134 Adliswil +41 (0)76 505 1149 (mobile) / +41 (0)44 668 1878 (office) +41 (0)44 668 1818 (fax) http://gwesp.tx0.org/ |
Thread Tools | |
Display Modes | |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
Winch operations | Edward Winchester | Soaring | 7 | April 13th 06 11:24 AM |
UAV's and TFR's along the Mexico boarder | John Doe | Piloting | 145 | March 31st 06 06:58 PM |
LIppmann reports a 950 meter winch launch with their Dynatec winch line - anything higher? | Bill Daniels | Soaring | 20 | December 27th 04 12:33 AM |
I need winch launch videos | Bill Daniels | Soaring | 21 | December 1st 04 06:41 PM |
Blanik Weak Link for Winch Launch??? | Gary Emerson | Soaring | 6 | February 24th 04 08:08 PM |