|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#6
November 1st 06, 03:01 PM
posted to rec.aviation.homebuilt,rec.aviation.ultralight
|
|||
|
|||
503 part name
There are at least 3 fan housings on ebay right now each for less than $100. Could you buy a fan housing and then cut off the parts you don't want? None for a 503 and all were from points ign engines (no CDI pickup "pods"). I have located and bought a cut-down fan housing with the CDI "pods" for $85 inc shipping as ignition housings are either too rare, or when they exist are too expensive. Thanks for the assistance. Dean A. Scott, mfa Owner / Animator Chrusion FX ------------------------ http://www.chrusion.com -- Posted via a free Usenet account from http://www.teranews.com 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Part 121 Regulations Question | GS | Piloting | 27 | August 31st 06 06:56 AM |
| Mini-500 Accident Analysis | Dennis Fetters | Rotorcraft | 16 | September 3rd 05 11:35 AM |
| BergFalke II/55 part. | Bruce Greeff | Soaring | 2 | May 12th 04 02:32 PM |
| The Internet public meeting on National Air Tour Standards begins Feb. 23 at 9 a.m. | Larry Dighera | Piloting | 0 | February 22nd 04 03:58 PM |
| Part 91 Commercial Glider Rides to be Outlawed? | Vaughn | Soaring | 9 | October 27th 03 09:26 PM |
Threaded Mode