|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#6
November 2nd 06, 03:06 AM
posted to rec.aviation.homebuilt
|
|||
|
|||
Source of large diameter thick wall tube
You might want to try Alan Steel in Redwood City, CA They have a lot of odd
sizes DP "Bill Daniels" bildan@comcast-dot-net wrote in message . .. This request isn't exactly for an airplane but it's for a glider winch. I need to find a source for small amounts of 6.5" OD 1" wall steel tube. I don't care too much about the alloy as long as it's reasonably strong and both machinable and weldable. Thanks in advance. Bill Daniels 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| 6061-T6 2"x4" rect tube source? | Mr.TwistAir | Home Built | 8 | December 11th 05 04:59 AM |
| Boeing Boondoggle | Larry Dighera | Military Aviation | 77 | September 15th 04 02:39 AM |
| NEED: Source for Aluminum Bar 1 Inch thick 4 Inches Wide | [email protected] | Home Built | 4 | March 16th 04 10:11 PM |
| Source for Aluminum Bar 1 Inch thick 4 Inches Wide | Jon Ritter | Home Built | 2 | March 9th 04 01:40 PM |
| NEED: Source for Aluminum Bar 1 Inch thick 4 Inches Wide | [email protected] | Aviation Marketplace | 0 | March 7th 04 04:06 PM |
Threaded Mode