![]() |
If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#17
|
|||
|
|||
![]()
On Thu, 09 Nov 2006 02:58:44 GMT, "Capt.Doug"
wrote: "Roger (K8RI)" wrote in message With that high compression engine? You can't even get an STC for an alternative fuel. Where STCs are not a consideration, high RPMs and less than full MAP can allow the use of autogas. Performance may take a hit, and sometimes timing To me performance is paramount. I'm building the G-III to go as fast as possible. Long haul and some serious play. I don't even run the Debonair under 75% except for maneuvers, a rough ride, and landing. That engine IO-47N (260 HP) doesn't qualify for an STC either. My goal is to get similar HP to the one shown in KitPlanes this month. must be retarded for the turbocharged engines, but it works. I ran autogas in my first Aztec (NOT US registered!!!!!!) for years. The only difference was that I had to turn on the boost pumps on above 7000' for vapor lock. D. Roger Halstead (K8RI & ARRL life member) (N833R, S# CD-2 Worlds oldest Debonair) www.rogerhalstead.com |
Thread Tools | |
Display Modes | |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
BWB has finished his Lancair Legacy... | John Ammeter | Home Built | 1 | June 6th 06 04:11 AM |
A friend of mine is building a Legacy and has a question.... | John Ammeter | Home Built | 14 | April 23rd 06 11:17 PM |
Date of effect now 1 October 2004 for revised IGC-approvals for certain legacy types of GNSS flight recorder | Ian Strachan | Soaring | 0 | March 15th 04 02:32 PM |
Date of effect now 1 April 2004 for revised IGC-approval for certain legacy types of GNSS flight recorder | Ian Strachan | Soaring | 56 | December 2nd 03 08:08 AM |
Lancair Legacy 2000 | Randy L. | Simulators | 6 | October 9th 03 09:56 PM |