![]() |
If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#9
|
|||
|
|||
![]()
With the diode solution, when the system is turned on the battery with
the highest voltage will provide the current. As the battery draws down the second battery will come on line. From that time on both batteries will be providing power to the circuits. The strongest battery will provide the most current but both batteries will be stabilized at a common voltage. Therefore BOTH batteries will require re-charging after being used for any substantial period of time. Regarding the 3 position switch. The simple solution is to put a capacitor between ground and the output side of the switch. The capacitor must be large enought to provide the current needed during the switch switching time. This should not be a very large capacitor for our purposes. Brian Utley Gary Emerson wrote: COLIN LAMB wrote: "If both batteries are on-line all the time, how do you know when one is getting weak and needs to be replaced? Or do you replace both batteries when voltage is marginal at the end of a flight?" Well, that is a problem. You do not know. Everything is automatic. If you have one battery that has lost most of it's capacity, the good battery will do all the work. The only way you will know is when the total capacity of both batteries has been reduced. And, then, you will not know whether one battery has done 50% of the work and they are both down in storage ability, or one battery is still 90% and the other one is 10%. So, you will have to determine the capacity of each battery separately. You could test the battery capacity by switching either off during discharge, or even by using 2 ammeters - but it is becoming more complex once we try to extract more information. You can also determine the capacity during charge. Colin During any one flight, you don't need to know. What is a good idea is to test the batteries if you think you are losing capacity. During the week charge them up Monday and Tuesday, and Wednesday put a load on each one and see how long it lasts. Ideally, you'd like the load to test the batteries for as long as you'd normally fly. Say 4-6 hours unless you are typically flying for longer. If either one can't go the 4-6 hour distance and mainain a suitable voltage, then it's due for replacement. After the Wednesday test, charge them back up so you're ready for the weekend assuming they pass. I'd certainly do this in the spring and before any big contest during the year. 7Ah batteries are cheap in the grand scheme of things. |
Thread Tools | |
Display Modes | |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
Electric maned airplane | Flyingmonk | Piloting | 26 | July 20th 06 05:43 AM |
Electric maned airplane | Flyingmonk | Home Built | 26 | July 20th 06 05:43 AM |
Becker AR-3201 radio owners: check your batteries | sssarah | Soaring | 3 | May 24th 06 07:40 AM |
Switching Batteries Advice? | ContestID67 | Soaring | 17 | January 12th 06 01:02 AM |
Batteries, charger for Yaesu handheld - NiCad or NiMH? | David Herman | Owning | 10 | November 7th 04 04:30 PM |